• Users Online: 114
  • Home
  • Print this page
  • Email this page
Home About us Editorial board Ahead of print Current issue Search Archives Submit article Instructions Subscribe Contacts Login 
ORIGINAL ARTICLE
Year : 2018  |  Volume : 15  |  Issue : 3  |  Page : 192-198

Microtensile bond strength of self-etching adhesives to enamel


Department of Restorative Dentistry, Faculty of Dentistry, Cairo University, Giza, Egypt

Correspondence Address:
Ahmed Z Elhoshy
Associate Professor of Restorative Dentistry, Faculty of Dentistry, Cairo University, Cairo
Egypt
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/tdj.tdj_20_18

Rights and Permissions

Purpose It is uncertain whether single-step self-etching adhesives form bond to enamel as reliable as those of etch-and-rinse adhesives. This study compared the microtensile bond strengths to ground enamel of three one-step self-etching adhesive systems, a self-etching primer system and an etch-and-rinse adhesive system. Materials and methods Human enamel was ground flat with 320-grit silicon carbide paper. The self-etching adhesives Clearfil Tri S Bond (Kuraray), Futurabond NR (Voco) and Hybrid Bond (Sun-Medical), the adhesive with a self-etching primer Clearfil SE Bond (Kuraray) and the etch-and-rinse adhesive Admira Bond (Voco) were applied as directed, followed by a core of the same manufacturers' hybrid resin composite. A microtensile bond strength evaluation was performed after 48 h of water storage, using untrimmed beams ~1.0 ± 0.1 mm2 in cross-sectional area at a cross-head speed of 0.5 mm/min. Results There were no pretest failures in any group, and failures were predominately adhesive or mixed. Adhesion to enamel of Futurabond NR and Clearfil SE Bond was not significantly different from Admira Bond, while Clearfil Tri S Bond and Hybrid Bond demonstrated significantly lower bond strengths (one-way analysis of variance, Tukey–Kramer multiple-comparison test, P < 0.05). Clinical significance Bond strength to ground enamel of self-etching adhesive systems was dependant on the type of adhesive and some materials showed bond strength that was not different than that of etch-and-rinse system.


[FULL TEXT] [PDF]*
Print this article     Email this article
 Next article
 Previous article
 Table of Contents

 Similar in PUBMED
 Related articles
 Citation Manager
 Access Statistics
 Reader Comments
 Email Alert *
 Add to My List *
 * Requires registration (Free)
 

 Article Access Statistics
    Viewed107    
    Printed1    
    Emailed0    
    PDF Downloaded20    
    Comments [Add]    

Recommend this journal